Filter
Top Products
Checking the Engine Oil
Check the engine oil level daily. Never operate the
engine with the oil level below the low mark on the
dipstick. See your engine manual for oil
specifications and oil filter service instructions.
To check the oil level:
• Clean around the dipstick to prevent dirt from
entering the tube.
• Remove the dipstick and wipe off the oil.
• Put the dipstick back in place. Be sure it is all the
way down.
• Remove the dipstick again and note oil level.
• Add oil, if needed. Do not overfill.
• Put the dipstick back in place. Be sure it is all the
way down.
Changing the Engine Oil
• Read your engine manual for recommended
change schedule.
• Move the tractor to a level area. Lock the brake.
• If the engine is cold, let it run for 5 minutes.
• When the engine is warm, stop it and raise
the rear fender.
WARNING: Engine muffler and other
parts are hot.
• Clean the areas around the dipstick and
drain plug.
• Remove the dipstick.
• Put an open top container that will hold four quarts
under the drain plug.
• Remove the drain plug.
• Allow the engine to drain completely.
• Clean and reinstall the drain plug.
• Remove the oil filter (some models), clean the oil
filter port and install a new oil filter according to the
instructions on the oil filter.
• Fill with new oil to the “Full” mark on the dipstick.
• Replace the dipstick. Lower the rear fender.
• Start the engine and check for leakage at the drain
plug. Tighten the plug if leakage occurs.
Checking the Battery Fluid
Check the battery fluid every 200 hours. Use caution
and wear eye protection when checking the battery.
To check the battery:
• Clean the top of the battery.
• Lift the filler caps.
• If the fluid level is below the split rings in the filler
tube, add distilled water. Do not fit above the split
ring. Do not use a metal funnel.
• Reinstall the filler caps. Push them all the way
down.
Lubrication and Maintenance (Continued)
1
1. Grease Fitting on the Front Axle
Figure 3: Steering Axle Pivot
10
1
2
3
4
5
3
1. Grease Fittings for the Steering Arms
2. Grease Fittings for the Steering Columns
3. Adjusting Bolt
4. Lock Nut
5. Adjusting Nut
Figure 4: Steering Arms
PJ0370
PJ0380