Filter
Top Products
ASSEMBLY
A96B 03/06 Assembly Section 3-4
© 2006 Alamo Group Inc.
ASSEMBLY
TAIL WHEEL ASSEMBLY - LIFT TYPE
1. Attach Beam Support Weldments (2) to the Main Frame Assembly with 1/2” x 1-1/2” Bolts (6) &
Locknuts(7). (Figure Asm-R-0135)
2. Slide the Beam Weldment (1) through Bracket (3) and attach to the Mower Lugs with 5/8” x 4" Bolt(4) and
Locknut(5).
3. Remove Cotter Pin (8) and Washer (9) from Fork Pivot Shaft. Insert shaft into tube on end of Beam (1).
Reinstall Washer (9) and Cotter Pin (8).
4. Install 1/2” x 1-3/4” Bolts (6) through Beam Support Weldment (2) and Bracket (3). (Install through pair of
holes which will give approximate desired cutting height). Install Locknut (7).