Filter
Top Products
MAINTENANCE
A96B 03/06 Maintenance Section 5-20
© 2006 Alamo Group Inc.
MAINTENANCE
Step 5 Insert long punch into top end of output shaft and drive shaft, bearing cones and cups out of lower
housing (Figure Mnt-R-0125). Note! Drive shaft until lower bearing cup is out of housing.
Step 6 Remove slotted spanner nut from top end output shaft. Remove all parts except top bearing cup - which
should be loose in center housing cavity but not able to be removed. Using torch cut top bearing cup so it can
easily be removed (Figure Mnt-R-0126). Remove lower bearing cone from output shaft.
The Gearbox is now disassembled with the exception of the cone Bearing cup in Main Gearbox Housing, the
Oil Seal and Bearing Cup in the input cap, and the Oil Seal in the Output Cap. These items can be removed by
conventional means. Inspect and replace all worn or defection parts.
Step 7 Clean all parts especially main housing before any reassembly begins.
NOTE: Clean all parts before assembling Gearbox.