Filter
Top Products
ASSEMBLY
UGR 04/06 Assembly Section 3-6
© 2006 Alamo Group Inc.
ASSEMBLY
Then, while holding the handle to expose the plunger
rod, thread the threaded bead of the cable into the end
of the plunger rod and tighten securely. Release the
handle, allowing the cable to pull into the control stick
assembly.
Once cable is attached to plunger rod, slide the silver
conduit sleeve into the bottom of the control stick
assembly and align the groove in the conduit sleeve
with the cross screw hole.
Finally, reinstall the cross screw and tighten securely.