Filter
Top Products
ASSEMBLY
UGR 04/06 Assembly Section 3-5
© 2006 Alamo Group Inc.
ASSEMBLY
14. Adjust carriage bolt item 1 to obtain a com-
pression at impact point of 1/8”-3/16”
before STOP “S” hits the arm. Adjust return
spring tension (Item 2) to obtain desired
mower head return speed.
15. The Mower is now ready to operate. Read
the operating instructions and safety
instructions before putting the mower to
work.
There are obvious and hidden
potential hazards in the operation of this mower. REMEMBER! This machine is often
operated in rough terrain conditions and in heavy weeds. Serious injury or even death may
occur unless care is taken to ensure the safety of the operator, bystanders, or passersby in
the area.
CONTROL CABLE CONNECTION TO CONTROL STICK ASSEMBLIES
First remove the cross-screw from the bottom of the
Control Stick Assembly. DO NOT remove the screws
that fasten the two housing halves together.
Next, while holding the housing, fully shift the handle in
the control stick assembly to expose the female-
threaded end of the plunger rod.