Agri-Fab 45-0460 Spreader User Manual


  Open as PDF
of 24
 
5
FIGURE 5
FIGURE 6
5/16" x 1"
HEX BOLT
NYLON
WASHER
5/16"
NYLOCK NUT
MOTOR
ASSEMBLY
5/16" FLAT
WASHER
SCREEN
1/8" x 1-1/4"
COTTER PIN
SPREADER
SHAFT
CLIPS
CLIP
SCREEN
SHAFT
SEAL
BUSHING
Place screen down into hopper. 9. DO NOT place it under
theclipsinbottomofhopperatthistime.Seegure6.
Place motor assembly down into hopper, inserting end of 10.
spreader shaft into impeller coupler. Secure it with a 1/8"
x 1-1/4" cotter pin, spreading ends of pin around coupler.
Seegure5.
Fasten motor mount bracket to hopper using four 5/16" x 11.
1"hexbolts,5/16"atwashers,nylonwashersand5/16"
nylocknuts.Seegure5.
Lift screen up and slide seal down spreader shaft to rest 12.
againstplasticbushinginbottomofhopper.Seegure6.
Slide one edge of the screen under one of the clips. 13.
Then, slightly bow the screen to slide the opposite
sideofthescreenundertheotherclip.Seegure6.
FIGURE 7
5/16" x 1"
HEX BOLT
5/16" NYLOCK NUT
Attach the control mount tube to the top of the 14.
spreader using a 5/16 x 1" hex bolt and 5/16" nylock
nut.Seegure7.
NOTE: The end of the control mount tube with the smaller
bend should be attached to the spreader.
FIGURE 8
5/16" x 1"
HEX BOLT
5/16" NYLOCK NUT
Attachtheowcontroltothecontrolmountbracket15.
using a 5/16" x 1" hex bolt and a 5/16" nylock nut.
Seegure8.
 previous next