Agri-Fab 45-0460 Spreader User Manual


  Open as PDF
of 24
 
4
CAUTION: PARTS OF TRACTOR
MAY BE HOT! MAKE SURE ENGINE
AND MUFFLER ARE COOL BEFORE
INSTALLING SPREADER!
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED FOR ASSEMBLY
(1) Pliers
(2) 7/16" Wrenches
(2) 1/2" Wrenches
FIGURE 1
Turnthespreaderupsidedownasshowningure1.1.
Assemble two angle brackets and two 1/4" nylock nuts 2.
onto the ends of the longer bolts already assembled to
the frame tube. Do not tighten yet.Seegure1.
FIGURE 2
Fastendeectortoanglebracketsusingtwo1/4"x3.
3/4"hexbolts,1/4"atwashersand1/4"nylocknuts.
Allowanglebracketstoswivelsodeectorcurves
naturally between angle brackets and then tighten all
nuts.Seegure2.
Insert agitator hairpin into middle hole in the spreader 4.
shaft.Assembleaseal(turnedasshowningure
3) onto end of the spreader shaft closest to hairpin
agitator.Seegure3.
Slide end of spreader shaft having the seal through the 5.
plasticbushinginthebottomofhopper.Seegure3.
Slide the impeller onto the spreader shaft and secure 6.
itwitha1/8"x1-1/4"cotterpin.Seegure3.
FIGURE 3
ANGLE
BRACKET
1/4" NYLOCK NUT
1/4" FLAT
WASHER
DEFLECTOR
1/4" x 3/4"
HEX BOLT
1/4"
NYLOCK NUT
IMPELLER
1/8" x 1-1/4"
COTTER PIN
AGITATOR
HAIRPIN
SEAL
SPREADER
SHAFT
FIGURE 4
Assembleaseal(turnedasshowningure4)onto7.
the motor shaft. Slide it up against the motor.
Assemble the impeller coupler onto the motor shaft 8.
and secure it with a 1/8" x 1-1/4" cotter pin. Spread
theendsofthepinaroundthecoupler.Seegure4.
1/8" x 1-1/4"
COTTER PIN
SEAL
IMPELLER
COUPLER
 previous next