4
To lock the bag arm channels into position, secure 2.
each of them to the side of the sweeper housing
with a 5/16-18 x 3/4" hex bolt (17), a 5/16" jam nut
(25) (between the bag arm channel and the sweeper
housing)andaplasticwingnut(31).Seegure2.
Slide a pivot rod retainer (30) into each end of the 3.
bagarmchannels.Seegure3.
Insert a compression spring (32) into the bottom of 4.
each of the pivot rod retainers to secure them to the
bagarmchannels.Seegure3.
FIGURE 2
FIGURE 3
FIGURE 4
FIGURE 5
Attach the drawbar (14) to the sweeper by fastening 5.
a drawbar bracket (8) above and below the drawbar
with three 5/16" x 2-1/2" hex bolts (15) and 5/16"
nylocknuts(21).Seegure4.
Lock the drawbar into position by inserting a 3/8" x 3" 6.
hitch pin (20) into the center hole and securing it with
a3/32"cotterpin(19).Seegure5
17
31
25
20
19
8
15
14
21
8
30
32