Agri-Fab 45-03642 Spreader User Manual


  Open as PDF
of 12
 
5
FIGURE 4
12. Turn the spreader upright on its wheels.
13. Assembletheowcontrolmountingtubetothehitch
tubeusingtwo5/16"x1-3/4"hexbolts(A)and5/16"
nylock hex nuts (H). DO NOT TIGHTEN YET.Seegure
5.
14. Assemblethevinylcap(T)ontotheowcontrolmounting
tube.Seegure5.
FIGURE 5
9. Assembleaspacer(Q),a3/4"atwasher(L),awheel
(airvalvefacingout)andanother3/4"atwasher(L)
ontotheendoftheaxlethathasboththelarge and
small holes.Seegure4.
10. Installa1/8"x1-1/2"cotterpin(N)intothesmallhole
intheendoftheaxle.Seegure4.
11. Openthebailonthedrivepin(W)andinstallitthrough
thewheelandthelargeholeintheaxle.Closethebail
tolockthepininplace.Seegure4.
FIGURE 7
(H) 5/16" NYLOCK
HEX NUT
(A) 5/16" x 1-3/4"
HEX BOLT
(K) 5/16"
FLAT WASHER
OFF
ON
1
2
3
4
6
7
8
9
10
5
(W) DRIVE PIN
AIR VALVE
(Q) SPACER
(L) 3/4" FLAT
WASHER
(N) 1/8" x 1-1/2"
COTTER PIN
FIGURE 6
(B) 1/4" x 1-3/4"
HEX BOLT
(G) 1/4" NYLOCK
HEX NUT
HITCH BRACE
INNER
FLOW CONTROL
MOUNTING TUBE
HITCH BRACE
INNER
15. Assemblethetwoinnerhitchbracestotheowcontrol
mountingtubeusinga1/4"x1-3/4"hexbolt(B)anda
1/4"nylockhexnut(G).DO NOT TIGHTEN YET. See
gure6.
16. Tightenallnutsandboltsassembleduptothispoint.
Do not collapse the tubes when tightening.
17. Assembletheowcontrolmountingbrackettotheow
controlmountingtubeusingtwo5/16"x1-3/4"hexbolts
(A),four5/16"atwashers(K)andtwo5/16"nylockhex
nuts (H). DO NOT TIGHTEN YET.Seegure7.
(A) 5/16" x 1-3/4"
HEX BOLT
(H) 5/16" NYLOCK
HEX NUT
(T) VINYL CAP
FLOW CONTROL
MOUNTING TUBE
 previous next