Agri-Fab 45-03642 Spreader User Manual


  Open as PDF
of 12
 
4
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED FOR ASSEMBLY
(1) Pliers
(2) 7/16"Wrenches
(2) 1/2"Wrenches
(2) 9/16"Wrenches
REMOVAL OF PARTS FROM CARTON
Removeallpartsandhardwarepackagesfromthecarton.
Lay out all parts and hardware and identify using the
illustrations on pages 2 and 3.
FIGURE 1
FIGURE 2
FIGURE 3
CROSSOVER
TUBE
HITCH
TUBE
SHAFT
SUPPORT
PLATE
MIDDLE
LOCK
NUT
MIDDLE BOLT
(C) 1/4" x 2"
HEX BOLT
(B) 1/4" x 1-3/4"
HEX BOLT
(G) 1/4" NYLOCK
HEX NUT
(2) HITCH BRACES
OUTER
HITCH
TUBE
(2) HITCH BRACES
OUTER
STACK HITCH BRACES AS SHOWN
SMALL HOLE
(Q) SPACER
(L) 3/4"
FLAT WASHER
(N) 1/8" x 1-1/2"
COTTER PIN
AIR VALVE
1. Turnthespreaderupsidedownasshowningure1.
2. Removethelocknutfromthemiddleboltinthecrossover
tubeandshaftsupportplate.Leavetheboltinplace.
Seegure1.
3. Assemblethehitchtubeontothemiddleboltandsecureit
withthesamelocknutyouremoved.DO NOT TIGHTEN
YET.Seegure1.
IMPORTANT:Thehitchtubemustattachtothesideofthe
crossovertubeoppositetheshaftsupportplate.
ASSEMBLY
4. Stackthehitchbracesintotwosetsofthree,making
suretheraisedsidesofthebracesarefacingthesame
direction.Seegure2.
5. Assemblethesixhitchbraces(threeperside)tothe
insideofthehopperframeusinga1/4"x1-3/4"hex
bolt(B)and1/4"nylockhexnut(G)oneachside.DO
NOT TIGHTEN YET.Thehitchbracesshouldbeable
tomovefreely.Seegure2.
7. Assembleaspacer(Q),a3/4"atwasher(L),awheel
(airvalvefacingout)andanother3/4"atwasher(L)
onto the end of the axle that has only the small hole.
Seegure3.
8. Installa1/8"x1-1/2"cotterpin(N)intotheholeinthe
axle.Seegure3.
6. Assemblethetwoouterhitchbracesoneachsideto
thehitchtubeusinga1/4"x2"hexbolt(C)anda1/4"
nylock hex nut (G). DO NOT TIGHTEN YET. Do not
assemblethetwoinnerhitchbracesatthistime.See
gure2.
 previous next