Filter
Top Products
1 - Quick Reference
14
Front Panel Annunciators
φ
φφ
φ1
A list is initiated or running.
Prot
Indicates that a channel protection feature is active
on any channel. Press the Prot Clear key to clear
the protection condition.
CV
The selected input channel is in the
constant voltage (CV) mode.
Cal
Calibration mode is ON. Calibration can only be
done through the computer interface.
CC
The selected input channel is in the
constant current (CC) mode.
Shift
Indicates that the shift key has been pressed.
CR
The selected input channel is in the
constant resistance (CR) mode.
Rmt
Indicates that the electronic load is in remote state
(either GPIB or RS-232). In the remote state, only
the active key is the Local key.
Unr
The selected input channel is unregulated.
Addr
The electronic load is addressed to talk or listen.
Dis
The input is OFF. Press the Input on/off
key to turn the input on.
Err
A remote programming error(s) have occurred.
Tran
The selected input channel is enabled for
transient operation.
SQR
The electronic load is requesting a service.
Immediate Action Keys
A toggle switch that turns the input of the electronic load on or off.
Activates front panel control when the unit is in remote mode
(unless a Lockout command is in effect).
Increases the input current (CC), voltage (CV), or resistance (CR) in Meter mode.
Decreases the input current (CC), voltage (CV), or resistance (CR) in Meter mode.
Selects another channel.
+
Causes an initiate and trigger to occur. Used with transient subsystem or list.
Displays any protection functions that are tripped.
+
Resets the protection circuit and allows the unit to return to its last programmed state.
+
Identifies the module installed in the selected channel location. (not available)
Returns the front panel to metering mode from any other mode.
Input
On/Off
Local
Shift
Meter
Ident
Trigger
Protect
Shift
Shift
Prot
Clear
Prot
Clear
Shift
IdentShift
Q
QQ
Q
Channel
Q
QQ
Q
Input
Input