Filter
Top Products
1-12
Setting Up the Infiniium DCA
Step 5. Connect the Line Cord
Step 5. Connect the Line Cord
Connect the line cord as shown in the figure below.
The Infiniium DCA automatically adjusts for line input voltages in the range of
100 to 240 VAC. There is no manual selection switch. The line cord provided is
matched by Agilent to the country in which the order originates. Refer to
Table 1-8, “Available Line Cords,” on page 1-13 for a list of available line power
cords.
Install the instrument so that the detachable power cord is readily identifiable
and is easily reached by the operator. The detachable power cord is the
instrument disconnecting device. It disconnects the mains circuits from the
mains supply before other parts of the instrument. The front panel switch is