Filter
Top Products
10 Agilent 6000 Series Oscilloscopes Programmer’s Quick Start Guide
1 Setting Up
Using the GPIB Interface
1 Connect a GPIB cable from the controller PC’s GPIB interface to the “GPIB”
port on the back of the oscilloscope.
2 On the oscilloscope, verify that the controller interface is enabled:
a Press the Utility button.
b Using the softkeys, press I/O and Controller.
c Ensure the box next to GPIB is selected( ). If not( ), use the Entry
knob to select GPIB; then, press the Control softkey again.
3 Configure the oscilloscope’s GPIB interface:
a Press the Configure softkey until “GPIB” is selected.
b Use the Entry knob to select the Address value.