107FT-857 Operating Manual
MENU MODE No•057
[
MEM/VFO DIAL MODE
]
Function: Selects the function which is engaged when you press the SELECT knob thereby
activating its “secondary” function).
Available Values: CW SIDETONE, CW SPEED, MHz/MEM GRP, MIC GAIN, NB LEVEL,
RF POWER/STEP
Default: MHz/MEM GRP
MENU MODE No•058
[
MIC SCAN
]
Function: Enables/disables scanning access via the microphone’s
[
UP
]
/
[
DWN
]
keys.
Available Values: OFF/ON
Default: ON
MENU MODE No•059
[
MIC SEL
]
Function: The choice of the equipment which connects to the MIC jack.
Available Values: NOR/RMT/CAT
Default: NOR
NOR: Normal Microphone.
RMT: Optional MH-59A8J Remote Microphone.
CAT: CAT system: if you are using the optional FC-30 antenna tuner, you can still use the
CAT system by connecting the serial Data cable to the MIC jack.
MENU MODE No•060
[
MTR ARX SEL
]
Function: Selects the analog meter display configuration while the transceiver is receiving.
Available Values: SIG, CTR, VLT, N/A, FS, OFF
Default: SIG
SIG: Indicates the incoming signal strength.
CTR: Discriminator center meter.
VLT : Indicates the battery voltage.
N/A: Not available at this time.
FS: Applies a calibration signal (1 mA for full scale) at the METER Jack on the trans-
ceiver bottom, for adjustment of an external meter’s calibration. This lets you adjust
the external potentiometer in your metering system so that the external meter reading
is full scale.
OFF: Disables the meter.
MENU OPERATION
