NEC Electronics America NP-P350W Manual

A SERVICE OF

next previous

25

2. Projecting an Image (Basic Operation)

 Turning off the Projector

To turn off the projector:

1. First,pressthe (POWER)buttonontheprojector

cabinetorthePOWEROFFbuttonontheremotecon-

trol.

The [POWER OFF / ARE YOU SURE ? / CARBON SAV-

INGS- SESSION 0.000[g-CO2]] message will appear.

2. Secondly,presstheENTERbuttonorpressthe

(POWER)orthePOWEROFFbuttonagain.

The lamp will turn off and the projector will go into standby

mode. When in standby mode, the POWER indicator will

light orange and the STATUS indicator will light green when

[NORMAL] is selected for [STANDBY MODE].

PowerOn

Steady blue light

Standby

Steady

orange light

Press twice

CAUTION:

PartsoftheprojectormaybecometemporarilyheatediftheprojectoristurnedoffwiththePOWERbuttonorifthe

ACpowersupplyisdisconnectedduringnormalprojectoroperation.

Usecautionwhenpickinguptheprojector.

NOTE:

• WhilethePOWERindicatorisblinkingblueinshortcycles,thepowercannotbeturnedoff.

• Youcannotturnoffthepowerfor60secondsimmediatelyafterturningitonanddisplayinganimage.

• DonotdisconnecttheACpowersupplytotheprojectorwithin10secondsofmakingadjustmentorsettingchangesandclosing

themenu.Doingsocancauselossofadjustmentsandsettings.