26
11.0 - REPLACEMENT OF HYDRAULIC
CYLINDERS
Parts Affected:
• Front Cover - P/N 17652
• Left Side Cover - P/N 17656
• Left Lower Pan Cover - P/N 17654
• Left Lower Treadle Cover - P/N 17665
• Left Top Treadle Cover - P/N 17667
• Bolt - P/N 17677
• Cylinder Pivot Weldment - P/N 17586
• Hydraulic Cylinder - P/N SM17810
Tools Needed:
• Phillips screw driver (long & short shaft)
• Loctite 242 (blue)
• 3/8 Allen wrench
• 3/4 inch Socket
• 3/4 inch Open End Wrench
• #15 Torque wrench
To Remove the Hydraulic Cylinder:
Before performing the following steps make sure
that you note the location and position of all
hardware that is removed.
11-1: Stand on the right treadle to raise the left treadle to
full height.
11-2: Turn the power off and unplug the machine from the
wall outlet.
See Figure 1 for Steps 3 to 5.
11-3: Remove the Front Cover (P/N - 17652).
11-4: Remove the Left Side Cover (P/N - 17656) and Left
Side Pivot Cover.
11-5: Remove the Left Lower Pan Cover (P/N - 17654).
11-6: Unplug two lead wires from cylinder.
11-7: Remove Left Lower Treadle Cover (P/N - 17665).
11-8 Tilt the machine upward slightly and brace with a
block of wood under the machine to hold in place.
MECHANICAL SERVICE
Figure 1
FRONT COVER
LEFT
SIDE
COVER
LEFT LOWER PAN COVER
LEFT
SIDE
PIVOT
COVER
