12
5.0 - REMOVING UPRIGHTS
Tools Needed:
• 1/8 Allen bit
• 5/32 Allen bit
• 3/4 inch Socket
• Phillips head screw driver
5-1: Remove the Front Trim Cover (P/N - SM17652), Left
Side Cover (P/N - SM17656), Left Pan Cover (P/N
- SM17654) and Right Side Cover (P/N - SM17655),
Right Pan Cover (P/N - SM17653).
5-2: Remove the Rear Step Cover and weldment (see
Figure 5-1).
5-3: Remove the Rear Plastic Cover (P/N - SM17659 to
access the Upright Cables. (See Figure 5-2 and Figure
5-4.)
5-4: Disconnect three cables as follows:
A) From the VSD Board. See Figure 5-3.
Figure 5-1
Figure 5-2
Figure 5-3: I/O Connectors.
MECHANICAL SERVICE
detAching And moving the upright portion of
this product requires two people! you must
hAve A minimum of two people to properly
support the heAvy upright structure so the
console does not fAll And cAuse dAmAge to the
unit.
7 ! 2 . ) . '
! 4 4 % . 4 ) / .
$ ! . ' % 2
)--%$)!4%!#4)/.2%15)2%$
# ! 5 4 ) / .
to Avoid electricAl shock or dAmAge
to the unit you must power off the
unit And mAke sure All power hAs been
drAined from the unit And cApAcitors by
ensuring there Are no lighted leds on
the console.
7 ! 2 . ) . '
! 4 4 % . 4 ) / .
$ ! . ' % 2
)--%$)!4%!#4)/.2%15)2%$
# ! 5 4 ) / .
Cable Connector
