A SERVICE OF

logo

Chapter A Default Settings VXI/VME-MXI-2
© National Instruments Corporation A-7 PCI-Based MXI-2 Interface for Windows
MAX Settings
Table A-11.
Device Tab Default Settings
Editor Field Default Setting
Logical address Use DIP switch
Address space A24*
Requested memory 16 KB*
A24/A32 write posting Disabled
A16 write posting Disabled
Interlocked mode Disabled
* Assumes no DRAM is installed. If DRAM is installed, the Address space should be
A32, and Requested memory should match the amount of DRAM. If you install the
DRAM yourself, you must manually specify these changes.
Table A-12.
VXI/VME Bus Tab Default Settings
Editor Field Default Setting
Bus timeout value 125 µs
Slot 0 configuration Auto-detect
Auto retry Disabled
Transfer limit 256
Arbiter type Priority
Fair requester Enabled
Arbiter timeout Enabled
Request level 3