SETUP
SDP-5
3-55
PWR – the power trigger output connector – is not configurable. It is activated when the
SDP-5 is activated, and deactivated when the SDP-5 is deactivated. The trigger output
connector labeled 1 can be configured for remote or program operation.
Default Possible
Parameter Setting Settings
REMOTE ONLY OFF ON, OFF
Program Operation N/A ON, OFF
All TRIGGER SETUP menu parameters – except the REMOTE ONLY
parameter – are considered program operation parameters.
REMOTE ONLY ON, OFF
Configures the trigger output connector labeled 1 for remote operation. When set to ON, this
connector is configured for remote operation. When the Zone 2 command bank is activated, it
can be activated and deactivated with the remote control Mode and buttons (2-14). The
SDP-5 ignores all other TRIGGER SETUP menu parameter settings. When set to OFF, the trigger
output connector labeled 1 is not configured for remote operation. It can be configured for
program operation. Refer to the next page for more information about configuring the trigger
output connector labeled 1 for program operation.
REMOTE ONLY
SETUP
TRIGGER SETUP
Selecting the SETUP menu TRIGGER option opens the
TRIGGER SETUP menu shown at the right, which can
be used to configure the trigger output connector
labeled 1. The SDP-5 rear panel houses two 12V DC
trigger output connectors. The connector labeled
TRIGGER
