Human Touch HT-2580/iJoy-2580 Manual

next previous

5. Insert the metal plate behind the actuator shaft, aligning the holes on the ends of the plate with the holes on each side of the mounting bracket. IMPORTANT: Be sure the bracket

is turned so it is on the side of the screw holes opposite the actuator shaft (Fig.9).

6. Replace the two screws/washers to secure the metal plate to the bracket (Fig.10).

7. Align the mounting bracket holes with the corresponding holes on the back of the chair, then use a 4-mm Allen key to replace the four screws/washers (Fig.11).

8. Connect the actuator connectors to the corresponding connectors on the bottom of the chair, then secure the connectors using new zip ties (Fig.12).

9. Close the zipper on the bottom of the chair.

10. Plug in the chair, power it on, then verify that the chair now reclines/inclines properly.

Please send any questions or comments regarding these instructions to: documentation@humantouch.com

, LLC.

Metal plate

Mounting bracket

Actuator shaft

Black spacer

(Fig.9)

(Fig.10)

Phillips-head screw

Bracket

Using a 4-mm Allen Key,

remove the four screws

(Fig.11)

(Fig.12)

New actuator

Connectors

Actuator shaft