Human Touch HT-2580/iJoy-2580 Manual

next previous

1. From the bottom of the chair, thread the new actuator shaft up through the opening in the upholstery at the rear of the seat. IMPORTANT: Make sure the black spacer on each

side of the actuator shaft stays in place.

2. Align the actuator mounting point with the mounting bracket on the bottom of the chair, then replace the hinge pin and cotter pin to secure the actuator (Fig.7).

3. Flip the cloth down to cover the bottom of the chair.

4. Turn the two black spacers on the end of the actuator shaft so the short side is on top, then slide the spacers into the mounting bracket (Fig.8).

INSTALLING THE NEW ACTUATOR

(Fig.7)

Hinge pin

Cotter pin

New actuator

Black spacer Mounting brackerActuator shalf

(Fig.8)

Black spacer

Actuator shalf