A SERVICE OF

logo

Open as PDF
next previous
2
6. Using a needle-nosed pliers, remove the cotter pin that secures the backrest actuator mounting pin (Fig.4).
7. Using a needle-nosed pliers, remove the hinge pin (Fig.4).
(Fig.4)
Hinge pin
Cotter pin
8. Flip the underseat cloth back down to cover the actuator, then locate the bracket that holds the actuator shaft in place at the rear of the seat (Fig.5).
9. Using a 4-mm Allen Key, remove the four screws/washers that secure the bracket to the chair (Fig.5).
10. Using a Phillips-head screwdriver, remove the screw/washer on each side of the bracket, which secure the metal plate behind the shaft to the bracket, then remove the metal plate to
free the actuator shaft from the bracket (Fig.6).
11. Pull the actuator shaft down, through the opening in the upholstery, then remove the actuator from the bottom of the chair.
Bracket
Using a 4-mm Allen Key,
remove the four screws
(Fig.5)
(Fig.6)
Phillips-head screw