A SERVICE OF

logo

Open as PDF
next previous
92 3 Managing and maintaining the printer ENWW
Replacing the stapler unit
Removing and replacing the stapler unit
Use these steps to replace a defective stapler unit in the optional
stapler/stacker.
To remove and replace the stapler unit
1 Locate the stapler unit on the right side of the stapler/stacker.
2 Rotate the stapler unit toward the front of the printer until the unit
clicks. Hold the stapler unit in this open position.
3 Push down on the tab at the top of the stapler unit.
4 Hold the tab down and pull the stapler unit up and out of the stapler/
stacker.
5 Disconnect cable that connects the stapler unit to the stapler/
stacker. (Only the blue part detaches.) Release the white tab that
contains the blue cable connector by opening the tab to the left.
1
2
3
4
5