Link Settings
Sets the network link speed (10- or 100-Mbps) and communication
mode (full- or half-duplex) for the print server.
Caution! If you change the link setting, network communications
with the print server and the attached printer may be lost.
AUTO (the default) causes the print server to attempt to
automatically configure its port to match the network’s link
speed and communication mode. If it fails, then 100-Mbps,
half-duplex operation is set.
●
10TXFULL 10-Mbps, full-duplex operation●
10TXHALF 10-Mbps, half-duplex operation●
100TXFULL 100-Mbps, full-duplex operation●
100TXHALF 100-Mbps, half-duplex operation●
Syslog
Facility
Specifies the encoded source facility of a syslog message (for
example, to identify the source of selected messages during
troubleshooting). By default, the print server uses LPR as the
source facility code, but local user values of local0 through local7
can be used to isolate individual or groups of print servers. See the
syslog description. See also other syslog parameters in the TCP/IP
Settings menu.
Dynamic Raw
Port Setting
Allows additional ports to be specified for printing to TCP port
9100. Valid ports are 3000 to 9000, which are application
dependent.
Enable MFP
and AIO
software
support
Enable or disable the print server's support of the full-function
scanning facility installed on the computers (the client software
from the MFP's CD) for an HP multifunction (MFP or All-in-One)
device. Disabling this causes the print server to disallow all
functions other than printing over the network. (Support for basic
scanning using the print server’s Web Scan facility is separate; see
following parameter.)
Enable Web
Scan
Enable or disable use of the basic scanning facility provided by the
print server's embedded web server Scan page (details).
Availability of this facility is separate from support of the client’s
full-function scanning software (see preceding parameter).
The features include displaying and downloading scanned files.
Whether scanning to e-mail is also enabled with this facility is
determined by the setting of the following parameter.
Enable
Scan-to-email
Enable or disable use of the scanning to e-mail facility—sending
the file—provided by the print server’s embedded web server Scan
page (see preceding parameter).When this parameter is enabled,
scanning to email is available, in addition to displaying and
downloading scanned files. The e-mail facility is accessible for
users only when the mail server is set for the
Email (SMTP)
Server parameter (see following parameter).
