A SERVICE OF

logo

Open as PDF
next previous
77
190-00356-31 Rev. C
Clearing the Map Page
RoutinelyclearingtheMapPageofalldischarge
pointsisagoodwaytodetermineifastormisbuild-
ingordissipating.Inabuildingstormdischargepoints
reappearfasterandinlargernumbers.Inadissipating
stormdischargepointsappearslowerandinsmaller
numbers.
Clearing discharge points from the Map Page.
To clear the Map Page of all discharge
points:
1. From the default Nav Page, turn the small
right knob to select the Map Page.
2. Press MENU to display the Page Menu. Turn
the small right knob to select “Clear Storm
Data?” and press ENT.
Changing the Storm Data Display Range
Stormdatacanbedisplayedonthe2000NM
zoomscale,butthedataonlygoesoutasfarasthe
STORMSCOPEcanreport(200NM).The500NM
zoomscalewilldisplayalllightningdata.Scales
greaterthan500NMdonotdisplayanyadditional
STORMSCOPEdata.
Changing the storm data display range on
the Map Page.
To select a storm data display range:
1. From the default Nav Page, turn the small
right knob to select the Map Page. Press
MENU to display the Page Menu.
2. Turn the small right knob to select “Setup
Map?” and press ENT. Turn the small right
knob to select the Weather Group and press
ENT. Turn the large right knob to select the
desired lightning symbol option. Turn the small
right knob to select the desired range and
press ENT.
Section 2
L-3 Stormscope Interface