A SERVICE OF

logo

Open as PDF
next previous
381295 V1.4V 10/06
18
Operation
Powering the METER
Follow the steps below to power the Meter from a standard ac outlet.
1. Insert Power Adaptor into AC outlet.
2. Connect the Power Adaptor to the Meter.
3. I/O Turn the Meter on by holding this button for about 3 seconds.
4. The meter powers up configured as it was at last power down.
Changing Backlight
1. Press Backlight ON.
2. Press Backlight OFF.
Note: Using the meter without the backlight increases battery life by 1 hour
approximately.
Selecting items in a Menu
Follow steps ① through ⑤ to open a menu and choose an item.
Press FUNC to open the FUNCTION menu.
Scope SetUp Exit
F1 F2 F3 F4
Press F1 to open the Scope Setup menu.
SCOPE SETUP
INPUT A: INPUT B:
■ DC □ AC ■ DC □ AC
VERTICAL MODE:
□ CHA □ CHB ■ A&B
HORIZONTAL MODE:
■ NORM □ ROLL
MEASUREMENTS A:
■ DCV □ ACV □ OHM □ BZ
□ HZ □ RPM □ P/W □ DTY
Set Exit
F1 F2 F3 F4
Use the arrow keys to highlight an item
Press F3 to select an item
Press F4 to Exit