S-7200C
5. FUNCTION SETTINGS (G10 OPERATION PANEL)
40
<Setting item list>
Display
Setting item
Setting item
display
Setting value
display
Setting value or operation when setting
Default
value
[ UP] Needle up stop
Needle up/down stop [UPDN]
[ DN] Needle down stop
[ DN]
[ ON] Correction sewing
Correction sewing [CORR]
[ OFF] No correction sewing
[ OFF]
[ ON] Slow start
Slow start [SLOW]
[ OFF] No slow start
[ OFF]
[ ON] Thread trimming disabled
Thread trimming disable [TRDI]
[ OFF] Thread trimming enabled
[ OFF]
Start backtack speed [SBSP] [****]
Inching speed (*1)-3000
(Initial value depends on machine head
specifications)
[1200]
[1800]
[ ON] Automatic operation
Automatic operation
during continuous
backtack sewing
[CBAT]
[ OFF] No automatic operation
[ OFF]
[ OFF] No switching
[ 1]
Slow start only when sewing starts after
thread trimming
[ 2]
Slow start only when sewing starts after
sewing has been paused
Pedal response switching
settings immediately after
sewing has started
[SLMD]
[ 3] Slow start always when sewing starts
[ OFF]
Pedal response
immediately after sewing
has started
[SLPN] [ *]
* Setting range: 1-5
・ The larger the value, the slower is the
speed when sewing starts.
・ If [SLMD] is set to “OFF”, this setting is
disabled.
[ 1]
[ 2] A-B
[ 3] B-A-B
[ 4] A-B-A-B
[ 5] B-A-B-A-B
Start backtack sewing
pattern
[SBTP]
[ 6] A-B-A-B-A-B
[ 2]
[ 2] C-D
[ 3] C-D-C
[ 4] C-D-C-D
[ 5] C-D-C-D-C
End backtack sewing
pattern
[EBTP]
[ 6] C-D-C-D-C-D
[ 2]
[ 1] A, B, C, D Continuous backtack
sewing pattern
[RBTP]
[ 2] A, B × D
[ 1]
[ ON] Function available Quick reverse needle up
function
[ RUP]
[ OFF] Function not available
[ OFF]
[ ON] Function available Backtack matching
function
[BTAD]
[ OFF] Function not available
[ OFF]
(*1) The inching speed setting value is the value in the machine head memory.
