S-7200C
4.
FUNCTION SETTINGS (G50 OPERATION PANEL)
37
４-１４. Adjusting the sewing machine reference position
1
Change to sewing machine reference position adjustment mode
2
Select the adjustment item
* “1 Sewing machine reference position” is adjusted at the time of shipment from the factory.
* If you would like to change only the stop positions, make adjustments at “2 Needle up stop position” or “3
Needle down stop position”.
NOTE:
When an adjustment value is changed, the needle up and needle down signal positions will change.
Other settings such as solenoid operation timing and needle up/down stop positions will change in line
with this.
Main display
Adjustment item
Adjustment
item name (A)
Adjustment
value (B)
1
Sewing machine reference
position (Adjustment when
motor is replaced)
[MORG] -20-20 degrees
2
Needle up stop position (during
individual adjustment)
[UPOS] -5-10 degrees
3
Needle down stop position
(during individual adjustment)
[DPOS] -5-10 degrees
3
Set the adjustment value (B)
4
Save the adjustment value. The adjustment value (B) will change
from flashing to illuminated steadily.
NOTE:
Any changed settings will take effect after sewing machine
reference position adjustment mode has been exited.
5
The adjustment item name (A) and the
adjustment value for that item (B) will be
displayed in the main display (1) in orange.
* If you would like to clear the value which is being displayed, press
the
key.
* If the adjustment value is different from the original value, the
adjustment value will flash.
4192M
2043B 4173M
Sewing machine reference position adjustment mode will be exited and
normal operation will be possible.
(While pressing the key, press the power ON switch.)
2041B 2138M
4193M
2042B
