A SERVICE OF

logo

BES-962BC BES-1262BC
159
Chapter 6 Embroidering
Automatic Step Back
Sets the number of stitches for automatic step back if thread breakage occurs.
The number of stitches that can be set is from 0 to 255.
Additional step-back can be made for sensitivity value of the thread breakage sensor.
1. Select [Automatic Step Back] from Settings menu.
2. Enter the number of stitches for automatic step back.
3. Click [OK].
Automatic Hoop Feed
Sets automatic hoop feed for a thread breakage.
1.
Select [Automatic Hoop Feed] from Settings menu and put the check mark
(
).
Click here, and the value decreases/increases.
Click here to give additional step-back for the
sensing distance with the thread breakage sensor.