Filter
Top Products
MD6210M
GB-8
tainer approved for flammable liq-
uids.
h) Make sure the unit is properly as-
sembled and in good operating
condition.
i ) Do not use the machine near a
fire, as aiming the machine in the
direction of a flame may cause
flammable substances to ignite.
PRECAUTIONS WHEN
REFILLING CHEMICALS
• Before filling the tank with chemi-
cals, please make sure that the
spray lever is completely at rest.
• After chemical refilling, firmly
tighten the tank cap. If not fully
tightened the cap may become
loose during spraying, with the
risk of physical exposure to the
chemicals.
BEFORE STARTING THE
ENGINE
• Each time before starting the en-
gine, inspect the entire unit to see
if every part is in good order and
is securely tightened in place. If
any damage is found in the fuel
line, the exhaust line, or the igni-
tion wiring, do not use the ma-
chine until it has been repaired.
IMPORTANT
• Before starting operation, al-
ways make sure to check if any
obstacles are left inside the vo-
lute case and net. The obstacles
may cause damage on fan and
volute case and serious injury.
WARNING
• Check to see if the shock-absorb-
ing rubber mount has become
cracked or otherwise damaged.
Note that failing to replace this
rubber mount when it has be-
come cracked or damaged may
cause the engine to come loose
from its frame during use, thus
resulting in possible serious
bodily injury.
• If cracked, be sure to replace
without delay.
WARNING
•To reduce the risk of injury asso-
5. For safe operation
ciated with contacting rotating
parts, stop the engine before in-
stalling or removing attachments.
Do not operate without net in
place. Always disconnect the
spark plug before performing
maintenance or accessing mov-
able parts.
USING THE PRODUCT
WARNING
While using the product, if abnor-
mal noise or vibration occurs, stop
the engine immediately and con-
tact the nearest ZENOAH servic-
ing dealer for assistance. Check-
ing the fan is very important. If the
rotating fan should break up, it
might lead to serious accidents.
1. This machine, mister, is a back-
pack type, and is shouldered
while operating. The blow tube is
held with the control handle and
operated by right hand. And then
throttle is controlled by left hand.
2. Since protective clothing gener-
ally offers poor ventilation and
thus places stress on the body,
there is a risk of contracting heat-
stroke or other illness when oper-
ating for long periods under high
temperatures. Please avoid
spraying on hot days, aiming in-
stead for early morning and late
afternoon times when tempera-
tures are relatively cool and winds
are low.
3. Check the work area that the ma-
chine will be used in and remove
or cover all valuables that may be
damaged by the air blast or
thrown debris.
4. Make sure you can move and
stand safely. Check the area
around you for possible obstacles
(roots, rocks, branches, ditches,
etc.) in case you have to move
suddenly. Take great care when
working on sloping ground.
If the sprayer is tilted the chemi-
cal may leak out through the air
holes in the cap. When spraying
always make sure you have a firm
footing and maintain your bal-
ance.
5. To reduce the risk of injury asso-
ciated with thrown objects.