Filter
Top Products
MD6210M
GB-16
9. Maintenance
MUFFLER
WARNING
• Inspect periodically, the muffler for loose fasten-
ers, any damage or corrosion. If any sign of ex-
haust leakage is found, stop using the machine
and have it repaired immediately.
• Note that failing to do so may result in the engine
catching on fire.
IMPORTANT
• Before starting operation, always make sure to check
if the muffler is properly held by three bolts to the cyl-
inder. (Fastening Torque : 8~12 N·m)
• Even if one bolt out of three bolts is loose, the muffler
may get loose during operation which may result in
engine catching on fire.
PROCEDURES TO BE PERFORMED AFTER
EVERY 100 HOURS OF USE
1. Remove the muffler, insert a screwdriver into the vent,
and wipe away any carbon buildup. Wipe away any
carbon buildup on the muffler exhaust vent and cylin-
der exhaust port at the same time.
2. Tighten all screws, bolts, and fittings.
3. Check to see if any oil or grease has worked its way
in between the clutch lining and drum, and if it has,
wipe it away using oil-free, lead-free gasoline.
AIR INLET NET
IMPORTANT
• Blowing air is taken in from the air inlet net. When air
flow has dropped down during operation, stop the
engine and inspect the air inlet net for blocking by
obstacles.
• Note that failure to remove any such obstacles may
result in the engine becoming overheated and dam-
aged.
WARNING
Never use the machine without the net of the ma-
chine. Before each use, check that the net is at-
tached in place and is free from any damage.
SHOULDER STRAP
• If the shoulder strap is damaged it may break during
use, thus causing the product to fall and resulting in
personal injury. Follow the instructions below to re-
place the shoulder strap with new one.
1. Pass the upper end of the strap through the hanger,
making the FLAPPED SIDE OUTSIDE.
2. Put the end of the strap through the ring on the strap,
and then push the ring toward the hanger as close as
possible.
(1)Ring
(2)Flapped side
WARNING
The flap on the end of the strap works as a stop-
per. Never install the strap with the flapped side
inside, or the unit may fall from the operation,
which could result in injury to the operator and/or
damage to the unit.
(1)Air inlet net