Filter
Top Products
MD6210M
GB-17
G
B
WARNING
• When draining fuel, please be careful not to spill
it. If fuel is spilt, wipe off thoroughly. In addition,
please be sure to close the storage container cap
tightly.
IMPORTANT
• If fuel is left in the engine for protracted periods, the
inside of the carburetor may become clogged and
cause engine malfunction (faulty starting and insuffi-
cient output).
• During storage, slightly loosen the cap of the chemi-
cal fluid tank. If screwed too tightly, the gasket may
become distorted.
On completion of all work procedures, when not plan-
ning to use again for a protracted period please carry
out the following pre-storage care, to prevent trouble
caused by time-lapse changes.
10. Storage
11. Disposal
• When you dispose of the machine, do not disassemble
the machine.
• Do not simply discard empty chemical containers, but
dispose of them safely by incinerating, burying, or
another similar method. In addition, please take ev-
ery care that the water used to clean spraying tools
does not create any hazard.
• When disposing your machine, fuel or oil for the ma-
chine, be sure to allow your local regulations
1. Clean the chemical fluid tank and nozzle.
2. Remove dirt from the sprayer, inspect it for any dam-
age or looseness, and, if any abnormality is found,
correct it thoroughly in preparation for the next time
you use the unit.
3. Drain the fuel tank.
4. Start the engine, and leave it in idling condition until
all the fuel inside the carburetor is spent and the en-
gine comes to a natural stop.
5. Remove the spark plug and put a few drops (1 to 2
cc) of 2-cycle oil inside the engine. After pulling the
starter rope 2 or 3 times, return the spark plugs to
their original position and stop in compressed posi-
tion.
6. After oiling the throttle lever and other metal parts with
anti-corrosive oil, cover the sprayer and store unit in
a dry, dust free place, out of the reach of children.