Filter
Top Products
GB-8
LRTZ2600
MOUNTING ENGINE
1. Push the drive shaft housing toward the clutch hous-
ing and move it by hand to check that the drive shaft
is engaged with the gears.
2. Insert the drive shaft housing into the clutch housing
until it bottoms, and align the positioning holes on the
clutch housing and the shaft tube and install the screw.
When difficult to engage, twist the engine slightly.
3. Fasten the clamp securely with two screws.
WARNING
Never use any screws other than those specified by
the manufacturer, or the engine can get loose, result-
ing in a hazardous event.
IMPORTANT
Tighten the screws gradually by turns.
CONNECTING THROTTLE WIRE
1. Remove the air cleaner cover.
2. Connect the end of the throttle wire to the joint on the
top of the carburetor.
CONNECTING SWITCH WIRES
•Connect the switch wires between the engine and the
main unit. Pair the wires of the same color.
INSTALLING HANDLE
• Mount the handle to the shaft tube and clamp it at a
location that is comfortable to you.
6. Set up
Bolt
About 48cm
ATTACHING THE TRIMMING MECHANISM
1. Remove the cap on the end of the main pipe.
2. Remove the screw screwed into the end of the trim-
ming mechanism.
3. Insert the end of the trimming mechanism into the main
pipe.
4. Line up the hole on the end of the trimming mecha-
nism into which the screw is to be inserted with the
hole on the main pipe, and screw the screw firmly in.
5. Using a 10-mm wrench, screw in the hexagonal bolt
provided to fix the trimming mechanism into place.
BALANCE UNIT
1. Put on strap and attach unit to strap.
2. Depending on the working posture, slide clamp up or
down until unit balances and the strap fits your body.
(1) Main pipe
(2) Trimming
mechanism
(3) Screw hole
(4) Screw
(5) Fastening bolt