Filter
Top Products
GB-13
G
B
LRTZ2600
WARNING
Make sure that the engine has stopped and is cool
before performing any service to the machine. Con-
tact with moving cutting head or hot muffler may re-
sult in a personal injury.
AIR FILTER
• The air filter, if clogged, will reduce the engine perfor-
mance. Check and clean the filter element in warm,
soapy water as required. Dry completely before in-
stalling. If the element is broken or shrunk, replace
with a new one.
FUEL FILTER
• When the engine runs short of fuel supply, check the
fuel cap and the fuel filter for blockage.s
SPARK PLUG
• Starting failure and mis-firing are often caused by a
fouled spark plug. Clean the spark plug and check
that the plug gap is in the correct range. For a re-
placement plug, use the correct type specified by
ZENOAH.
• REPLACEMENT PLUG IS A NGK CMR7A.
9. Maintenance9. Maintenance
Fuel filter
Air Filter
TIGHTENING TORQUE:
87 ~ 104 in-lbs
(9.8 ~ 11.8 N.m.)
0.6 - 0.7 mm
IMPORTANT
• Note that using any spark plug other than those des-
ignated may result in the engine failing to operate
properly or in the engine becoming overheated and
damaged.
•To install the spark plug, first turn the plug until it is
finger tight, then tighten it a quarter turn more with a
socket wrench.
MUFFLER
WARNING
• Inspect periodically, the muffler for loose fasten-
ers, any damage or corrosion. If any sign of ex-
haust leakage is found, stop using the machine
and have it repaired immediately.
• Note that failing to do so may result in the engine
catching on fire.
SPARK ARRESTER
• The muffler is equipped with a spark arrester to pre-
vent red hot carbon from flying out of the exhaust out-
let. Periodically inspect and clean as necessary with
a wire brush.
Spark arrester