Filter
Top Products
GB-6
HB250
morning or late at night when
people might be disturbed. Com-
ply with times listed in local ordi-
nances.
2. To reduce sound levels, limit the
number of pieces of equipment
used at any one time.
3. Operate power blowers at the
lowest possible throttle speed to
do the job.
4. Check your equipment before op-
eration, especially the muffler, air
intakes and air filters.
WORKING PLAN
• When planning your work sched-
ule, allow plenty of time to rest.
Limit the amount of time over
which the product is to be used
continuously to somewhere
around 30 ~ 40 minutes per ses-
sion, and take 10 ~ 20 minutes of
rest between work sessions. Also
try to keep the total amount of
work performed in a single day
under 2 hours or less.
FUEL
WARNING
To reduce the risk of fire and burn
injury:
a) Handle fuel with care. It is highly
flammable.
b) Do not smoke while handing fuel.
c) Do not refuel a hot engine.
d) Do not refuel a running engine.
e) Avoid spilling fuel or oil. Always
wipe unit dry before using.
f) Move at least 3 meters (10 ft.)
away from the fueling point be-
fore starting engine.
g) Always store gasoline in a con-
tainer approved for flammable liq-
uids.
h) Make sure the unit is properly as-
sembled and in good operating
condition.
BEFORE STARTING THE
ENGINE
• Each time before starting the en-
gine, inspect the entire unit to see
if every part is in good order and
is securely tightened in place. If
any damage is found in the fuel
5. For safe operation
line, the exhaust line, or the igni-
tion wiring, do not use the blower
until it has been repaired.
IMPORTANT
• Before starting operation, always
make sure to check if any ob-
stacles are left inside the volute
case. The obstacles may cause
damage on fan and volute case
and serious injury.
WARNING
• Never use the blower without the
screen at the air intake of the
blower. Before each use, check
that, the screw (1) is securely
tightened and is free from any
damage.
• Never remove debris from the in-
take screen while the engine is
running. Contact with rotating
blower fan may result in a serious
personal injury.
(1) Screw
(2) Air intake screen (Air inlet net)
WARNING
• To reduce the risk of injury asso-
ciated with contacting rotating
parts, stop the engine before in-
stalling or removing attachments.
Do not operate without net in
place. Always disconnect the
spark plug before performing
maintenance or accessing mov-
able parts.
USING THE PRODUCT
1. Check the work area that the
blower will be used in and remove
or cover all valuables that may be
damaged by the air blast or
thrown debris.
2. To reduce the risk of injury asso-
ciated with thrown objects.
a) Watch out for children, pets, open
windows or freshly washed cars,
and blow debris safely away.
b) Use the full blower nozzle exten-
sion so the air stream can work
close to the ground.