Filter
Top Products
50
11. Maintenance of Saw Chain and Guide Bar
English
Make sure every cutter has the same length and edge
angles as illustrated. (F33)
(1) Cutter length
(2) Filing angle
(3) Side plate angle
(4) Top plate cutting angle
■ GUIDE BAR
• Reverse the bar occasionally to prevent partial wear.
• The bar rail should always be a square. Check for
wear of the bar rail. Apply a ruler to the bar and the
outside of a cutter. If a gap is observed between
them, the rail is normal. Otherwise, the bar rail is
worn. Such a bar needs to be corrected or replaced.
(F34)
(1) Ruler
(2) Gap
(3) No gap
(4) Chain tilts
F33
F34
RedMax Part Number
Bar Size Guide Bar Saw Chain
16” (45cm) G0021 33SL-66X
For replacement use only above bars and chains or
the following:
OREGON BAR
16 inch DUBLE GUARD™ Pro bar
Mount code #A195.
OREGON CHAIN
33SL