A standard saw unit package contains the items as
shown below. (SE1)
(1) Power unit
(2) Guide bar
(3) Saw chain
(4) Plug wrench
Open the box and install the guide bar and the saw
chain on the power unit as follows.
The saw chain has very sharp edges. Use
protective gloves for safety.
1. Pull the guard towards the front handle to check
that the chain brake is not on.
2. Loosen a nut and remove the chain cover.
3. Fix the hanger on the rear of power unit by
screw. (SE2)
(1) Hanger
4. Mount the guide bar then fit the saw chain
around the bar and sprocket.(SE3)
Pay attention to the correct direc-tion of the
saw chain
5. Fit the chain tensioner nut into the lower hole of
the guide bar, then install the chain cover, and
fasten the mounting nut to finger tightness.
(SE3)(SE4)
(1) Hole
(2) Moving direction
(3) Chain tensioner nut
When installing the chain cover, be sure to fit
the hook completely at the rear end of the
cover.
WARNING
WARNING
WARNING
5. Installing guide bar and saw chain
❲
8
❳
SE1
SE2
SE3
SE4