Filter
Top Products
❲
12
❳
■ STARTING ENGINE
1. Feed fuel and chain oil into their respective
tanks and tighten the caps securely. (OP1)
(1) Fuel
(2) Chain oil
2. Continuously push the priming bulb until fuel
comes in the bulb. (OP2)
3. Put the switch to the "I" position. (OP3)
(1) Switch
4. Pull out the choke knob to the second-stage
position. The choke will close and the throttle
lever will then be set in the starting position.
(OP4,5)
(1) Throttle lever
(2) Throttle interlock
(3) Choke knob
(a) when the engine is cool
(b)when the engine is warm up
(c) after the engine starts
When restarting immediately after stopping the
engine. Choke knob in the first-stage position
(choke open and throttle lever in the starting
position)
NOTE
7. Operation
OP1
OP2
OP3
OP4
OP5