Zenoah EXZ2500S-BC, EX-BC, EX-LRT, EX-PS, EX-HE Brush Cutter User Manual


 
9. Maintenance (EX-PS only)
The bar rail should always be a square. Check for
wear of the bar rail. Apply a ruler to the bar and the
outside of a cutter. If a gap is observed between
them, the rail is normal. Otherwise, the bar rail is
worn. Such a bar needs to be corrected or
replaced.(MA4)
(1) Ruler
(2) Gap
(3) No gap
(4) Chain tilts
SPROCKET
Check for extensive wear, and replace it when the
teeth are worn over 0.3mm. (MA5)
(1) Sprocket
SAW CHAIN
It is very important for smooth and safe
operation to keep the cutters always sharp.
Your cutters need to be sharpened when:
Sawdust becomes powder-like.
You need extra force to saw in.
The cut way does not go straight.
Vibration increases.
Fuel consumption increases.
Cutter setting standards:
Be sure to wear safety gloves.
Before filing:
Make sure the saw chain is held securely.
Make sure the engine is stopped.
Use a round file of proper size for your chain.
Chain type : 90SG
File size : 5/32 in (4.0mm)
Place your file on the cutter and push straight
forward. Keep the file position as illustrated. (MA6)
WARNING
WARNING
EX-PS
MA4
EX-PS
MA5
EX-PS
MA6
41