Filter
Top Products
■ MOUNTING ENGINE (SE1)
1. Push the driveshaft housing toward the clutch
housing and rotate it by hand to check that the
driveshaft is engaged with the gears.
2. Insert the driveshaft housing into the clutch
housing until it bottoms, and align the positioning
holes on the clutch housing and the shaft tube
and install the screw. When difficult to engage,
twist the engine slightly.
3. Fasten the clamp securely with two screws.
Tighten the screws gradually by turns.
■ CONNECTING THROTTLE WIRE
1. Remove the air cleaner cover.
2. Connect the end of the throttle wire to the joint
on the top of the carburetor. (SE2)
■ CONNECTING SWITCH WIRES
• Connect the switch wires between the engine
and the main unit. Pair the wires of the same
color.
■ INSTALLING HANDLE
(EX-BC, EX-LRT only) (SE3)
• Install the handle to the shaft tube and clamp it
at a location that is comfortable to you.
(1) About 19 inches (48cm)
(EX-PS only) (SE4)
• Insert the grip to the shaft tube.
• Fasten the clamps with screws.
(EX-HE only) (SE5)
• Install the J-shaped handle to the shaft tube and
clamp at a position best for your job.
■ JOINT ATTACHMENT (SE6)
• Insert the attachment to the main shaft.
• Tighten the knob bolt securely.
(1) Knob bolt
IMPORTANT
6. Set up
SE1
SE2
(1)
SE3
SE5
(1)
SE6
SE4
13