Filter
Top Products
(EX-HE only)
■ STARTING ENGINE
The RedMax stick edger is designed for edging
lawn in gardens, parks, roadsides and so on.
Before starting the engine, take the operating
position and adjust the handle position and the
wheel height as necessary.
ADJUSTING HANDLE POSITION
• Loosen the handle bracket screws and re-
position the handle to your best operating
position. Re-tighten the screws. (OP1)
ADJUSTING WHEEL HEIGHT
• Loosen the clamp lever and change the wheel
height to obtain desired cutting depth. (OP2)
(1) Deep cut
(2) Shallow cut
• Never adjust wheel height with the engine
running.
The cutting head will start rotating upon the
engine starts.
1. Feed fuel into the fuel tank and tighten the cap
securely. (OP3)(1)
(EX-PS only) Feed the chain oil into the oil tank
and tighten the cap securely, too. (OP3)(2)
(1) Fuel
(2) Chain oil
2. Rest the unit on a flat, firm place. Keep the
cutting head off the ground and clear of
surrounding objects as it will start rotating upon
starting of the engine.
3. Push the primer pump several times until
overflown fuel flows out in the clear tube. (OP4)
4. Move the choke lever to the closed position.
(OP5)
5. Set the ignition switch to the “start” position.
While pulling the throttle lever, push the set
button, and release the throttle, then the throttle
WARNING
WARNING
8. Operation
OP4
(1)
(2)
(3)
OP5
OP1
OP2
OP3
21