Filter
Top Products
12
CUTTER HOUSING SPINDLE ASSEMBLYSCUTTER HOUSING SPINDLE ASSEMBLYS
CUTTER HOUSING SPINDLE ASSEMBLYSCUTTER HOUSING SPINDLE ASSEMBLYS
CUTTER HOUSING SPINDLE ASSEMBLYS
The cutter housing assembly is designed with a slip fit
inner race and pulley. The sole purpose of the setscrew
in the pulley is to hold the housing assembly together.
The setscrew is not ment to secure the pulley. The
pulley is secured by pinching the pulley to the inner race
of the bearings using the blade bolt and nut. Tighten the
setscrews after you have pinched the assembly together
with the blade bolt and nut.
Each cutter spindle on 48" Models have a different stack
up of spacers and pulleys, to achieve proper belt
alignment. The left cutter spindle on 48" Models is the
same as 32" and 36" Models. See figure #8 (Refer to
the Kutter parts manual when ordering parts.)
SERVICESERVICE
SERVICESERVICE
SERVICE
Cutter housing assemblys use sealed bearings and
are maintance free.
NOTENOTE
NOTENOTE
NOTE
WHEN PRESSING A BEARING IN OR OUT OF AWHEN PRESSING A BEARING IN OR OUT OF A
WHEN PRESSING A BEARING IN OR OUT OF AWHEN PRESSING A BEARING IN OR OUT OF A
WHEN PRESSING A BEARING IN OR OUT OF A
CUTTER HOUSING APPLY CONSTANTCUTTER HOUSING APPLY CONSTANT
CUTTER HOUSING APPLY CONSTANTCUTTER HOUSING APPLY CONSTANT
CUTTER HOUSING APPLY CONSTANT
PRESSURE TO THE RACE OR RACES THATPRESSURE TO THE RACE OR RACES THAT
PRESSURE TO THE RACE OR RACES THATPRESSURE TO THE RACE OR RACES THAT
PRESSURE TO THE RACE OR RACES THAT
HAVE AN INTERFERENCE FIT.HAVE AN INTERFERENCE FIT.
HAVE AN INTERFERENCE FIT.HAVE AN INTERFERENCE FIT.
HAVE AN INTERFERENCE FIT.
NEVER BEAT A BEARING IN OR OUT. NEVER BEAT A BEARING IN OR OUT.
NEVER BEAT A BEARING IN OR OUT. NEVER BEAT A BEARING IN OR OUT.
NEVER BEAT A BEARING IN OR OUT.