Filter
Top Products
10
OPERATING INSTRUCTIONSOPERATING INSTRUCTIONS
OPERATING INSTRUCTIONSOPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
6. Pull starter rope until engine starts.
7. Warm engine momentarily, then move the throttle
control out of the choke position until engine runs
smoothly, approximately 1/2 throttle. Engage the blades
and set the desired rpm. The best cutting and bagging
is obtained with engine at or near top rpm.
NOTE: DO NOT engage the blades at full rpm. ToNOTE: DO NOT engage the blades at full rpm. To
NOTE: DO NOT engage the blades at full rpm. ToNOTE: DO NOT engage the blades at full rpm. To
NOTE: DO NOT engage the blades at full rpm. To
extend belt life engage and disengage belts at 1/extend belt life engage and disengage belts at 1/
extend belt life engage and disengage belts at 1/extend belt life engage and disengage belts at 1/
extend belt life engage and disengage belts at 1/
2 throttle.2 throttle.
2 throttle.2 throttle.
2 throttle.
8. Depress one operator presence lever and shift
transmission to the desired gear.
9. Unlock the traction levers by pushing the thumb
latches forward. Slowly release both traction levers at
the same time to begin forward motion.
10. The steering system of this mower uses indvidual
right and left traction levers on the handle bars. Squeezing
the traction lever will reduce tension on the wheel drive
belt eliminating power to that wheel. With the opposite
wheel still under power a turn is accomplished. If the
traction lever is squeezed even tighter the brake will be
applied to that wheel and a tighter more abrupt turn is
accomplished. - turn left by squeezing the left hand
traction lever or turn right by squeezing the right hand
traction lever. If you squeeze both levers the mower will
stop.