Yard-Man 31AE993I401 Snow Blower User Manual


 
5
SECTION 2: ASSEMBLING YOUR SNOW THROWER
NOTE: Any reference in this manual to the left or right
side of the snow thrower is observed from the
operator’s position.
Unpacking
Remove staples from the top, sides, and ends of
the shipping crate.
Set panels aside to avoid tire punctures or personal
injury.
Remove and discard plastic bag that covers unit.
Roll the unit out of the crate.
Check the crate thoroughly for loose parts before
discarding.
Loose Parts
The augers are secured to the auger shaft with two
shear bolts and hex lock nuts. If you hit a foreign
object or ice jam, the snow thrower is designed so
that the bolts may shear. Two replacement shear
bolts and nuts are provided for your convenience.
Store in a safe place until needed. See Figure 1.
Figure 1
IMPORTANT:
NEVER replace the auger shear bolts with
standard hex bolts. Any damage to the auger gearbox
or other components from standard hex bolts will not be
covered by your snow throwers warranty.
Assembling Handle
WARNING: Disconnect the spark plug
wire and ground it against the engine to
prevent unintended starting.
IMPORTANT:
Make any final adjustments, as instructed
later on in this section, before operating your snow
thrower. Failure to follow these instructions may cause
damage to the snow thrower.
Remove the lower plastic wing nut, cupped washer
and carriage bolt from each side of the lower
handle. See Figure 2.
Figure 2
Raise the upper handle assembly until it locks over
the lower handle. See Figure 3.
Look at the lower rear of the snow thrower frame to
be sure all the cables are aligned with the cable
roller guides.
Figure 3
Secure the upper handle and lower handle with the
two plastic wing nuts, cupped washers and carriage
bolts previously removed. Attach these hardware
on the lower hole in the handles.
Tighten the two wing nuts already in place on the
upper holes and secure the handles firmly.Slide the
shift rod connector down over the end of the lower
Shear Bolts
Hex Lock
Nuts
Wing Nut
Cupped Washer
Carriage Bolt
Lower Handle
Upper Handle
Tighten these
Wing Nuts
Steering Cable
Cable Tie
Clutch Rod
Connector
Upper Shift Rod
Upper Shift Rod
Wing Nuts
Upper Handle
Handle Panel
Lower Handle