Filter
Top Products
.
.
REPLACING SAFETY SHEAR BOLT
CHUTE CHAIN AND-ADJUSTMENT
To tight~n the chute chain, rotate the chute all the way to
the left, until the adjustment bolt is accessible. Tighten the
adjustment nut to tighten the chain. ..' :
." .,,' ,
CAUTION: Chain must be kept snug on chute housing. "
CHUTE CABLE ADJUSTMENT
SHIFT PANEL ADJUSTMENT
To
set or adjust the shift panel for correct speeds, place
master clutch control in neutral position and the shift lever
into the fifth speed notch. Loosen the two mounting bolts
and push shift lever right as far as allowed, hold, and
tighten mounting bolts. DO NOT ATTEMPT TH IS AD-
JUSTMENT WITH THE ENGINE RUNNING. To check
adjustment, start engine, move shift lever to first speed
notch and engage master clutch control. Unit should move
forward very slowly.
If first or reverse speeds are not satisfactory with this ad-
justment, move panel to the right for a faster first speed.
Move panel to the left for a faster reverse speed.
NOTE: Adjustment section continued on page 12.
If the intake snow reel should jam causing the safety shear
bolt to shear, it may be replaced with a new bolt, furnished
in the parts bag, after removing the broken pieces in the
shaft. NOTE: Always align the hole in the reel shaft and the
sprocket shaft before driving out the broken bolt. Do NOT
remove solid pin located near shear bolt hole.
Remove cable roller cover, loosen the locking bolt on top
! of the cable roller bracket and tighten the adjustment bolt
on the side.
CAUTION: The cable should not be adjusted too tightly,
adjustment should allow the spout to rotate freely.
Retighten the locking bolt and replace the cable roller
cover.