Yard Machines 840 Thru 849 Lawn Mower User Manual


 
Remove the tour screws which secure the seat to
the seat pivot bracket.
NOTE: If the seat was shipped in a box, remove four
screws from the bottom of the seat and place the seat in
position against the seat pivot bracket.
Turn the seat around and place in positionagainst
the seat pivot bracket, liningup the slotted holes in
the pivotbracket with the holes inthe seat. Select
desired position for the seat, and secure with the
four screws. See Figure 4.
QuickAdjustmentSeat
Figure 5
Pull out tab on seat stop and hold open while sliding
seat out of seat pivot bracket. See Figure 5.
Turn the seat around and line up plastic seat
spacers with the slots in seat pivot bracket.
Slide seat in until frontseat spacer engages the
seat stop. See Figure 6. To adjust the seat refer to
the adjustment section in this manual.
Figure 6
NOTE: If the seat was shipped in a box, line up plastic
seat spacers with the slots in seat pivot bracket and
slide seat in until front seat spacer engages seat stop.
,_ WARNING: Quick adjustment seat only:Before operating tractor, stand behind the
seat and pull back on if to make sure the seat
is engaged in the seat stop.
AttachingDeckLinks
(Hardware A)
The three adjustable deck links have been shipped
unassembled. Attach as follows.
Q
Start 1/2" hex nuts on eyebolts until nuts are
flushed with ends of eyebolts. See Figure 7.
Insert eyebolts and hex nuts into the adjustable lift
links located under the if'actor. See Figure 7.
Thread eyebolts into the liftlinks and hex nuts. The
left rear link should be adjusted so the eyebolt
bangs about 3-1/2 inches below the lift link,The two
front links should be adjusted so the eyebolts hang
about 2-1/8 inches below the liftlinks. See Figure 7.
_dtlngfor
Left Rear Link
Figure 7
AttachingtheDeck
(Hardware B)
NOTE: An assistant may be helpful for thisjob.
Working beneath the tractor, remove the hairpin
clip securing the round belt guard to the idler. See
Figure 8. Remove the two hex bolts which act as
belt keepers by the engine pulley.
Hex Bolts
Flgure 8
10