Filter
Top Products
14
snow thrower has already been operated. Tip the
snow thrower so that it rests on the auger housing.
See Figure 18.
• Remove the frame cover underneath the snow
thrower by removing six self-tapping screws. For
location of the frame cover, see Figure 18.
Figure 18
• When the traction control is released, there must be
clearance between the friction wheel and the drive
plate in all positions of the shift lever. When the
traction control is engaged, the friction wheel must
contact the drive plate. See Figure 19.
Figure 19
• If any one of these are not occuring, adjustment is
necessary. Follow the steps below to adjust the
traction control.
• Loosen the lock nut on the traction control cable
and thread the cable in or out as necessary.
Tighten the lock nut to secure the cable when
correct adjustment is reached. Reassemble the
frame cover.
NOTE: If you placed plastic under the gas cap earlier,
remove it now.
Auger Control
• To adjust the auger clutch, refer to Final Assembly
and Adjustments on page 9.
Carburetor
WARNING: If any adjustments need to be
made to the engine while the engine is
running (e.g. carburetor), keep clear of all
moving parts. Be careful of muffler, engine
and other surrounding heated surfaces.
• Minor carburetor adjustment may be required to
compensate for differences in fuel, temperature,
altitude and load.
• Refer to the separate engine manual, packed with
your unit, for carburetor adjustment information.
Drive Wheels
• The wheels may be adjusted for two different
methods of operation. Follow the steps below for
adjustment. See Figure 20.
Figure 20
One Wheel Driving
• On the right side of the unit, place klick pin in the
outside axle hole only. Do not place pin through
wheel hub. This position gives power drive to the
left wheel only, making the unit easier to maneuver.
Both Wheels Driving
• Rotate wheel assembly to align hole in the hub with
the inner hole on the axle shaft. Insert klick pin in
the hole. Outer axle shaft hole should be visible.
See Figure 20.
Frame Cover
Auger Housing
Friction
Wheel
Gear Shaft
Drive
Plate
Gap
Outside
Hole in Axle
Klick Pin in Hub
and Inner
Axle
Hole
Hole