Yard Machines 580 Series Lawn Mower User Manual


 
4
serious personal injury. Keep a firm hold on the
handle and walk, never run. If you feel you are
losing your footing, RELEASE THE BLADE
CONTROL HANDLE IMMEDIATELY and the blade
will stop rotating within three seconds.
Mow only in daylight or good artificial light.
Stop the blade when crossing gravel drives, walks
or roads.
If the equipment should start to vibrate abnormally,
stop the engine and check immediately for the
cause. Vibration is generally a warning of trouble.
Shut the engine off and wait until the blade comes
to a complete stop before removing the grass
catcher or unclogging the chute. The cutting blade
continues to rotate for a few seconds after the
engine is shut off. Never place any part of the body
in the blade area until you are sure the blade has
stopped rotating.
Never operate mower without proper guards, grass
catcher, plates or other safety protective devices in
place.
Muffler and engine become hot and can cause a
burn. Do not touch.
Only use accessories approved for this machine by
the manufacturer. Read, understand, and follow all
instructions provided with the approved accessory.
If situations occur which are not covered in this
manual, use care and good judgment. Contact your
dealer for assistance. Telephone 1-800-800-7310
for the name of your nearest dealer.
Do not adjust the throttle control while the engine is
still running.
2. Slope Operation
For your safety, use the slope gauge included as part of
this manual to measure slopes before operating this unit
on a sloped or hilly area. If the slope is greater than 15
degrees as shown on the slope gauge, do not operate this
unit on that area or serious injury could result.
Do:
Mow across the face of slopes; never up and down.
Exercise extreme caution when changing direction
on slopes.
Watch for holes, ruts, hidden objects, or bumps.
Tall grass can hide obstacles.
Always be sure of your footing. A slip and fall can
cause serious personal injury. If you feel you are
losing your balance release the blade control
handle immediately and the blade will stop in less
than 3 seconds.
Do not:
Do not mow near drop-offs, ditches or
embankments. The operator could lose footing or
balance.
Do not mow slopes greater than 15 degrees as
shown on the slope gauge.
Do not mow on wet grass. Reduced footing could
cause slipping.
3. Children
Tragic accidents can occur if the operator is not alert to the
presence of children. Children are often attracted to the
mower and the mowing activity. Never assume that
children will remain where you last saw them.
Keep children out of the mowing area and under
the watchful care of a responsible adult other than
the operator.
Be alert and turn mower off if a child enters the
area.
Before and while moving backwards, look behind
and down for small children or other objects.
Never allow children under age 14 to operate the
mower. Children 14 years of age and above
should read and understand the operation
instructions and safety rules in this manual.
Use extreme care when approaching blind corners,
shrubs, trees, or other objects that may obscure
your vision of a child or hazard.
4. Service
Use extreme care in handling gasoline and other
fuels. They are extremely flammable and the
vapors are explosive.
Use only an approved gasoline container.
Never remove gas cap or add fuel while the engine
is running. Allow engine to cool at least two
minutes before refueling.
Replace gasoline cap securely and wipe off any
spilled gasoline before starting the engine as it may
cause a fire or explosion.
Extinguish all cigarettes, cigars, pipes and other
sources of ignition.
Never refuel machine indoors because flammable
vapors will accumulate in the area.
Never store the machine or fuel container inside
where there is an open flame or spark such as a
gas water heater, space heater, or furnace.
Never run an engine inside a closed area.
To reduce fire hazard, keep mower free of grass,
leaves, or other debris build-up. Clean up oil or fuel
spillage. Allow mower to cool at least 5 minutes
before storing.
Before cleaning, repairing, or inspecting, make
certain the blade and all moving parts have