Filter
Top Products
11
• Install the other wheel assembly and the other end of the axle shaft in the same way.
• Remove the blocks from the rear of the mower and place the rear height adjusters in the same relative
position as the two front height adjusters.
Attaching Starter Rope
NOTE: The rope guide is already attached to the right side of the upper handle of your mower.
• With the spark plug wire disconnected and grounded, hold the blade control handle against the upper
handle, and pull the starter rope out of the engine.
• Slip the rope through the rope guide. See Figure 9. Tighten the wing nut holding the rope guide to the
upper handle.
Figure 9
Chute Deflector
The chute deflector is held in an upright position during shipping by means of a retainer. Remove this retainer
following the steps below.
• Lift the spring-loaded chute up towards the engine and remove the retainer. Lower the chute carefully into
the operating position keeping fingers out of the way.
WARNING: The chute retainer is used for shipping purposes only. It must be removed from the chute
deflector and discarded before operating the mower.
Figure 10
Installing Mulching Baffle (Optional)
A mulching kit (OEM 190-110) is available for the mowers shown in this manual. To obtain a mulching kit,
contact the local retailer or service dealer. Some lawn mower models covered in this manual may already be
equipped with the optional mulching baffle. If yours is one of these, install the baffle following the steps below.
• Lift the chute deflector up and slide the notches at the bottom of the mulching baffle over the lip of the
discharge opening. See Figure 11.
Wing Nut
Rope Guide
Chute Deflector
Chute Retainer