Filter
Top Products
9
Step 3. Tighten wing nuts.
Step 4. Raise complete handle assembly until it
clicks into place. Make sure not to kink
the control cables.
Step 5. Pinch lower handle against mounting
bracket with pliers.
Step 6. Move hairpin clip from outer to inner
hole on handle mounting bracket.
Step 7. Attach control cables to handle with pull
ties found on the handle.
Step 8. Loosen the wing nut holding the rope guide to the upper handle.
Step 9. Squeeze the blade control handle against the upper handle and pull out starter rope, slowly!
Step 10. Thread starter rope into rope guide.
Step 11. Tighten wing nut.
HERE
C
L
I
C
K
Handle Assembly
Control Cables
PINCH HERE
HERE
Rope Guide
Wing Nut
Look Here
Blade Control Handle
Upper Handle
Starter Rope
SQUEEZE